Yes, the Curt Echo Mobile Trailer Brake Controller part # C51180 has been tested by the manufacturer from distances up to 50' through multiple barriers. Therefore, you should not have any issue at all using this on your 40' diesel pusher motor home. The air brakes will pose no issues to the Curt Echo either. view full answer...
The best option we have would be the Swagman RV bumper rack part # S80600. This is a 4 bike rack that you could probably configure the trike onto with your other bike but I don't have a specific way it would work. Hopefully the rear wheels would line up with the slots on the rack but if not there should still be a way to secure the trike to the rack. view full answer...
The JWM62A actually replaced the # JWM60A and we decided to keep the old part number on our site. So if you ordered a # DV1230BL you'd actually get the current updated version JWM62A. view full answer...
I think I found some information that'll help you install a brake controller, like the Prodigy P2 # 90885, but we don't carry a direct plug-in adapter for that connector you found.
From my research it is the correct connector so you've found the correct wires. You need to cut off the plug you found and test each wire for function to make sure you know which is which and then hardwire them to the controller. Use a circuit tester like # PTW2992 to test the connector you found. The wire... view full answer...
The brake circuit of the Tekonsha Prodigy P3 # 90195 is on a different circuit than the lights for your trailer which is why everything else it working great but the controller is having issues.
Since your note is saying that the trailer isn't connected you need to check the blue wire from the controller to make sure it's running without any issues to the back of your motorhome. You likely have this wire damaged, pinched, or exposed somewhere which is causing a misreading. If you can't... view full answer...
I reach out to Lippert and was able to determine that the Replacement Gear Motor Assembly for Slide-Out Motor Assembly # LC387523 would be the correct replacement for your PowerGear 521271 slide out motor. view full answer...
The Rear View Safety Backup Camera part # RVS-811 comes with an adapter which allows you to hook up the camera to an external device such as a monitor from a different brand. In order to confirm compatibility with said brand you'd simply need to look for RCA jacks on the monitor which will be color coded with yellow and red markings. I have attached a photo of this adapter. In regards to the tilt feature, you will need to attach an additional power wire. view full answer...